www中文字幕-wwxx全免费视频-ww久久-ww毛片-ww欧美-ww亚洲ww亚在线观看

Your Position: Home > Support > FAQ

Oil Shortage Phenomenon and Replacement of Vacuum Oil Filter Oil Products

2019/8/1??????view:

  1. Check oil

  The oil level of the pump in operation must be located in the middle of the oil level glass window (6/4). If necessary, stop the pump and refuel according to the correct amount of oil. Excessive oil filling causes oil loss at high suction pressure.

  High fuel consumption generally indicates that the exhaust filter is blocked.

  When filling oil into the pump, the pump must be stopped.

  Check oil level at least once a day.

  2. Oil state

  Generally speaking, oil is clear and transparent. If the oil is dark, it should be replaced.

  If gases or liquids are dissolved in the oil, the limit pressure will deteriorate. Closing the inlet and opening the ballast valve to make the pump run for about 30 minutes can degasse the oil.

  When the pump is still at working temperature after stopping, some oil is discharged into beakers or similar containers through the discharging screw (6/5), which can be used to check the state of oil.

  warning

  According to the process involved, hazardous substances can spill over from pumps and oils. Corresponding safety measures should be taken.

  Comply with safety regulations.

  3. Change oil, change oil filter

  Tools used:

  Oil filter wrench (710 73 532)

  Always change oil when the pump is still at working temperature after shutdown.

  If the oil is in danger of polymerization of process gases in contact with it, the oil should be changed immediately after the pump is running.

  warning

  Pumps are hot in operation. Some surfaces can be as high as 80 (176).

  There is a risk of scald if touched.

  Turn off the drain plug (6/5) and let the used oil drain into the proper container.

  warning

  According to the process involved, hazardous substances can spill out of the pump or pump oil. Corresponding measures should be taken.

  Comply with safety regulations.

  Important Notes

  When handling used oil, please observe the relevant environmental regulations!

  When discharging oil, when the flow of oil decreases, screw the discharging screw on, start the pump for a short time (up to 10 seconds), and then stop the pump. Then screw down the oil drain plug to drain the remaining oil.

  Remove the oil filter (6/25), take a new oil filter, soak it with oil, and screw it on by hand.

  Re-install the drain plug (check the "O" ring and replace it with a new one if necessary).

  Remove the filling screw plug (6/6) and inject new oil into the lower edge of the oil level window, so that the pump can run for a short time, so as to flush the pump with the filling new oil. Then let the oil go.

  Use only the appropriate oil (see Section 1.8).

  warning

  According to the process involved, hazardous substances can spill over from pumps and oils. Corresponding measures should be taken. Comply with safety regulations.

  Watch out

  Do not install used seals; be sure to install new seals.

  Important Notes

  When handling used oil, please observe the relevant environmental regulations!


主站蜘蛛池模板: 国产亚洲欧美在线播放网站 | 丁香六月婷婷精品免费观看 | 成人免费在线播放 | 国产不卡在线视频 | 国产精品激情综合久久 | 日本三级动作片 | 亚洲欧美高清 | 99最新网址| 亚洲精品在线播放视频 | 伊人精品视频在线观看 | www中文字幕| 国产成人一区二区视频在线观看 | 色网站在线播放 | c逼视频 | 97影院午夜在线观看视频 | 久草在线免 | 娇妻终于接受了3p的调教 | 国产高清一区二区三区四区 | 一区免费视频 | 牛牛a级毛片在线播放 | 日韩欧美在线播放 | 天天综合天天综合 | 精品国精品国产自在久国产不卡 | 色综合色综合 | 国产在线不卡视频 | 欧美国产三级 | 青青成人在线 | 国产成人一区在线播放 | a级在线| 婷婷综合五月中文字幕欧美 | 国产精品男女 | 国产成人高清一区二区私人 | 最新国产在线观看 | 全免费一级毛片在线播放 | 久久精品人人做人人爽 | 国产亚洲欧洲精品 | 91性视频| linode日本iphone强汉视频 | 久久精品国产只有精品66 | 久久精品亚洲精品一区 | 国产欧美日韩图片一区二区 |